High and 1 3 4 in.
Pocket door hardware instructions.
Nail the end plate to the wall studs.
Once the frame is in place it s time for the pocket door installation.
Do not use jambs with dado s.
Step 1 read the directions.
The everbilt 36 in.
Follow the manufacturer s instructions and cut the pocket door header and track assembly to length with a hacksaw.
Check that the track is level so that the door rolls easily.
Bumpers pads slides door hardware home hardware household hangers knobs pulls.
Pocket door frame set the everbilt 36 in.
Purchase a pocket door kit at a hardware store.
Install the track according to the thickness of the header.
The door rides through a channel made by what are called split studs these studs function like regular wall studs but are metal wrapped and form a hollow channel in the middle for the pocket door to pass through.
Vertically and the door rough opening should be 4 in.
Prime line 2 pack 1 125 in plastic pocket door bottom guide.
Item 264668 model n 7015n 7015.
Its door panels are adjustable up to 5 8 in.
If needed use a hand saw to cut the track that came with your pocket door hardware so that it s 1 8 inch shorter than the opening.
1 574 293 5664 m f 8 00am 5 00pm est.
Pocket door frame set is designed for use with doors up to a maximum of 80 in.
Most are under 100.
Install finished jambs split header and casing as shown.
For doors inch thick install the track flush with the header.
Make sure that the hardware is for the thickness and the type of door that you are installing the hardware for and take note of any warnings or special notes the manufacturer gives.
Fasten split header on 1121 lock lever side with screws for future door removal or adjustment.
Attach the split studs to the floor and to the header checking for plumb.
This kit should contain the door split studs that allow the door to retract into the wall a track on which the door runs into the wall and door hardware.
Répétez l opération avec l autre roulette et attache de porte.
Wherever you purchased your pocket door hardware start by reading the directions that come with the door hardware that you purchased.
You may be able to find pocket doors at lumberyards too.
Higher than the door panel height.