Proper Gap For Shpwer Glass Doors

To cover up the space they installed a transparent flap that s supposed to close the gap.

Proper gap for shpwer glass doors.

The gap you are showing is 3 8 that s about 1 8 to 3 16 above the accepted norm. The gap from glass to glass where the strike side of the door meets the fixed panel at the vertical gap is normally 3 16. If your shower includes a knee wall it is better to include in line panel in your design. Measure the opening height.

Determine the distance from wall to wall at the top and bottom of the opening. The door guy said 24 inches is a good number depending of course on your ceiling height. Kitchen bath and glass. I design frameless showers every day and install the complicated ones.

I ve asked the contractor to replace it. This doesn t seem unreasonable. That s with floor to door top height of 7 feet. That way you can modify the fixed panel to accommodate the knee wall instead of trying to modify the door.

If these differ select a door using the larger width for a bypass door or the smaller width for a pivot door. We use 1 4 at the hinge side and 3 16 at the strike side. The measurements should be to the nearest 1 16 inch. The standard tolerance for frameless shower glass is plus or minus 1 8.

The glass was custom measured but when the door was installed the gap between the door and the adjacent glass isn t uniform. It is 1 8 at the top and 3 8 at the bottom. As the door is currently installed the strike side gap is 1 1 8 at the top 1 3 8 in the middle and 1 1 2 at the bottom. This is a new construction not an existing bathroom.

Hinge side gap is 5 at the top 25 in the middle and 25 at the bottom. It s important to keep in mind the limitations of the fabricator and the installer. The gap from glass to glass where the strike side of the door meets the fixed panel at the vertical gap is normally 3 16. This is the industry standard.

I think they did this to try and mask the gap. To my dismay there s a 1 2 inch space between the glass door and the adjoining glass attached to the wall as well as at the bottom of the door itself. It s important to keep in mind the limitations of the fabricator and the installer. The top of a knee wall will be made of glass.

In other words the swinging shower door cannot be notched to accommodate the knee wall. There are many variables that effect the gap you can achieve the 1st of them is the glass fabricator they cut the glass to one size and then polish it down to the finished size the standard for the industry is or 1 8 that a whopping 1 4. This is the industry standard.