To cut a metal threshold use tin snips and a saw equipped with a metal cutting blade to make the cuts.
Replace garage door threshold on concrete.
We had it repaired by a concrete resurfacing company once and it didn t even last the first winter.
The driveway is asphalt butting up to the concrete threshold entering the garage.
Be careful not to accidentally saw into your flooring.
Cut the old threshold with a back saw or a reciprocating saw.
The concrete threshold or whatever its called is broken and crumbling.
Remove the screws from the rotted threshold with a large flat tip screwdriver.
Replacing an exterior door threshold plate is not difficult in most cases.
Tap the end of the chisel with a.
2 mix a moderate amount of liquid detergent with 1 quart of water in a plastic.
1remove the old exterior threshold.
If there s carpeting trim the carpet where frayed material hangs loosely.
Insert the tip of a wood chisel between the seam of the threshold and concrete.
Open the exterior door fully.
When the saddle is in place restore the door jamb adding calk so that it fits nicely.
Begin by removing the existing threshold from your door.
Remove dirt and debris from chips and hairline cracks in the concrete threshold using a stiff bristle cleaning brush.
Remove all debris from the concrete slab.
They did remove it and replace the concrete but we don t know if they reinforced it with.
Drive any raised concrete anchors flush with the surface.