Here is how to fix it.
Reset sliding door on pontiac van.
When i turn off the car and take the keys out of the ignition there is a loud irritating noise from the right sliding door on the passenger side.
Any time i press the key fob you can still hear this sound from the sliding door.
There could be more than one general motors van with a failing power sliding door others may find that.
Open and close the power sliding doors twice with the overhead or b pillar switch to relearn the position.
If the power sliding door or power tailgate doesn t work properly after above procedure have the system checked by an authorized kia dealer.
Move the power sliding door switch to off then move it back to on this switch is located to the left of the steering wheel.
Make sure the power sliding door overhead switch is off.
Open the door with the remote a third time.
While looking at the lower track where the door assembly rolls start to close the door about 2 inches or so.
Once the third cycle completes the power door battery is reset.
For the left right power sliding doors and power tailgate follow above steps to reset.
There was a time when the doors stop locking with the key fob.
Open the door as far as it will go.
The procedure shown here is on a 2006 toyota sienna but the ideas and techniques should apply to most van sliding doors.
A common problem on uplanders is the sliding door roller fails.
The door will have to be relearned.
Open the sliding door and locate the bearing near the bottom.
Press the open button on the remote key fob to open the sliding doors.
Do not grease the rollers as the grease will pick up all foreign matter and will cause more problems with the door.
If the door reverses and or stops prior to completing the two cycles the procedure will need to be repeated.
Sliding door on 2001 pontiac montana.
Wait 10 seconds then open the door with the remote again.
Close the sliding door completely using the transmitter or main control button on the overhead console.
The power sliding door fuse will have to be removed for 1 min.
Close the door and wait 10 seconds.
Any help recommendaitons would be greatly appreciated.
Turn the ignition on.
